Frost depth in Oregon
Oregon has two code depths: 12 inches in 24 inches — and which one applies depends on the county you build in. Add 6 inches of bearing and that becomes a dig depth of 18" / 30". The numbers below are the code values an inspector measures, not climate averages — the local building department always has the final word.
| Area / zone | Frost depth | Dig depth | Set by |
|---|---|---|---|
| West of the Cascades | 12" | 18" | ORSC R403.1.4 (12 in minimum) |
| East of the Cascades (Bend, Pendleton) | 24" | 30" | Local Table R301.2(1) |
Two rows, two numbers: the county you build in decides which one governs your permit. Never take the shallower value to a counter in a deeper zone.
Why Oregon's number looks the way it does
The Cascades are Oregon's frost line: 12 inches west of them in the maritime Willamette Valley, 24 east of them in Bend and Pendleton, where the climate turns continental.
From frost depth to dig depth in Oregon
Footings bear on undisturbed soil below the frost line, so the hole goes 6 inches deeper than the code number. In Oregon that means:
| Code frost depth | Dig depth | Shortest Sonotube |
|---|---|---|
| 12" | 18" | 4 ft tube |
| 24" | 30" | 4 ft tube |
A 4-inch gravel base at the bottom of the hole is common practice for drainage, and if you use one, add it to the tube length rather than the dig depth — the footing still has to reach the full 12–24 inches below grade.
How much concrete a footing takes in Oregon
Bags of 80-lb mix per footing, for a solid pier with no post in the hole, at Oregon's code depth:
| Frost depth | 10" hole | 12" hole | 16" hole | 20" hole |
|---|---|---|---|---|
| 12" (18" dig) | 2 bags | 2 bags | 4 bags | 6 bags |
| 24" (30" dig) | 3 bags | 4 bags | 6 bags | 10 bags |
The bags calculator converts any total into 80, 60, 50 or 40-pound bags, and the concrete calculator handles slab and footing volumes.
Oregon frost depth FAQ
How deep is the frost line in Oregon?
Oregon has two code depths, and the county you build in decides which one an inspector measures: 12 inches in West of the Cascades, and 24 inches in East of the Cascades (Bend, Pendleton). These are code values, not the average depth the ground actually froze last winter.
How deep do footings have to go in Oregon?
Bearing sits below the frost depth, so dig to the code depth plus 6 inches: 12 inches of frost means a 18-inch dig, and 24 inches of frost means a 30-inch dig in Oregon. The extra 6 inches is the bearing layer that keeps the footing from sitting on frost-susceptible soil, and it is what ORSC R403.1.4 (12 in minimum) expects to see on a permit drawing.
How do I know which Oregon zone my county is in?
The citation in the table above names the authority that drew the lines — ORSC R403.1.4 (12 in minimum); Local Table R301.2(1). Your county or city publishes its own amendment to IRC Table R301.2(1) (or its own zone map), and that local document, not a state table, is what a permit reviewer checks. One call to the building department settles it before you rent an auger.
Plan a pour in Oregon
Other states
Last updated: 2026-11-02