Frost depth in New Mexico
New Mexico has two code depths: 18 inches in 30 inches — and which one applies depends on the county you build in. Add 6 inches of bearing and that becomes a dig depth of 24" / 36". The numbers below are the code values an inspector measures, not climate averages — the local building department always has the final word.
| Area / zone | Frost depth | Dig depth | Set by |
|---|---|---|---|
| Albuquerque & south | 18" | 24" | Local Table R301.2(1) |
| Santa Fe & northern mountains | 30" | 36" | Local Table R301.2(1) |
Two rows, two numbers: the county you build in decides which one governs your permit. Never take the shallower value to a counter in a deeper zone.
Why New Mexico's number looks the way it does
New Mexico climbs from 18 inches around Albuquerque and the south to 30 in Santa Fe and the northern mountains — high-desert elevation again, drawn in two code zones.
From frost depth to dig depth in New Mexico
Footings bear on undisturbed soil below the frost line, so the hole goes 6 inches deeper than the code number. In New Mexico that means:
| Code frost depth | Dig depth | Shortest Sonotube |
|---|---|---|
| 18" | 24" | 4 ft tube |
| 30" | 36" | 4 ft tube |
A 4-inch gravel base at the bottom of the hole is common practice for drainage, and if you use one, add it to the tube length rather than the dig depth — the footing still has to reach the full 18–30 inches below grade.
How much concrete a footing takes in New Mexico
Bags of 80-lb mix per footing, for a solid pier with no post in the hole, at New Mexico's code depth:
| Frost depth | 10" hole | 12" hole | 16" hole | 20" hole |
|---|---|---|---|---|
| 18" (24" dig) | 2 bags | 3 bags | 5 bags | 8 bags |
| 30" (36" dig) | 3 bags | 4 bags | 7 bags | 11 bags |
The bags calculator converts any total into 80, 60, 50 or 40-pound bags, and the concrete calculator handles slab and footing volumes.
New Mexico frost depth FAQ
How deep is the frost line in New Mexico?
New Mexico has two code depths, and the county you build in decides which one an inspector measures: 18 inches in Albuquerque & south, and 30 inches in Santa Fe & northern mountains. These are code values, not the average depth the ground actually froze last winter.
How deep do footings have to go in New Mexico?
Bearing sits below the frost depth, so dig to the code depth plus 6 inches: 18 inches of frost means a 24-inch dig, and 30 inches of frost means a 36-inch dig in New Mexico. The extra 6 inches is the bearing layer that keeps the footing from sitting on frost-susceptible soil, and it is what Local Table R301.2(1) expects to see on a permit drawing.
How do I know which New Mexico zone my county is in?
The citation in the table above names the authority that drew the lines — Local Table R301.2(1). Your county or city publishes its own amendment to IRC Table R301.2(1) (or its own zone map), and that local document, not a state table, is what a permit reviewer checks. One call to the building department settles it before you rent an auger.
Plan a pour in New Mexico
Other states
Last updated: 2026-11-02