Frost depth in Arizona
Arizona has two code depths: 12 inches in 30 inches — and which one applies depends on the county you build in. Add 6 inches of bearing and that becomes a dig depth of 18" / 36". The numbers below are the code values an inspector measures, not climate averages — the local building department always has the final word.
| Area / zone | Frost depth | Dig depth | Set by |
|---|---|---|---|
| Phoenix & low desert | 12" | 18" | IRC R403.1.4 minimum; local Table R301.2(1) |
| High country (Flagstaff, Show Low) | 30" | 36" | Local amendment to IRC Table R301.2(1) |
Two rows, two numbers: the county you build in decides which one governs your permit. Never take the shallower value to a counter in a deeper zone.
Why Arizona's number looks the way it does
Elevation, not latitude, writes Arizona's frost rule. The Phoenix and Tucson desert floor almost never freezes past a few inches, so 12 inches suffices there, while Flagstaff and the Show Low high country at 6,000 to 7,000 feet demand 30.
From frost depth to dig depth in Arizona
Footings bear on undisturbed soil below the frost line, so the hole goes 6 inches deeper than the code number. In Arizona that means:
| Code frost depth | Dig depth | Shortest Sonotube |
|---|---|---|
| 12" | 18" | 4 ft tube |
| 30" | 36" | 4 ft tube |
A 4-inch gravel base at the bottom of the hole is common practice for drainage, and if you use one, add it to the tube length rather than the dig depth — the footing still has to reach the full 12–30 inches below grade.
How much concrete a footing takes in Arizona
Bags of 80-lb mix per footing, for a solid pier with no post in the hole, at Arizona's code depth:
| Frost depth | 10" hole | 12" hole | 16" hole | 20" hole |
|---|---|---|---|---|
| 12" (18" dig) | 2 bags | 2 bags | 4 bags | 6 bags |
| 30" (36" dig) | 3 bags | 4 bags | 7 bags | 11 bags |
The bags calculator converts any total into 80, 60, 50 or 40-pound bags, and the concrete calculator handles slab and footing volumes.
Arizona frost depth FAQ
How deep is the frost line in Arizona?
Arizona has two code depths, and the county you build in decides which one an inspector measures: 12 inches in Phoenix & low desert, and 30 inches in High country (Flagstaff, Show Low). These are code values, not the average depth the ground actually froze last winter.
How deep do footings have to go in Arizona?
Bearing sits below the frost depth, so dig to the code depth plus 6 inches: 12 inches of frost means a 18-inch dig, and 30 inches of frost means a 36-inch dig in Arizona. The extra 6 inches is the bearing layer that keeps the footing from sitting on frost-susceptible soil, and it is what IRC R403.1.4 minimum expects to see on a permit drawing.
How do I know which Arizona zone my county is in?
The citation in the table above names the authority that drew the lines — IRC R403.1.4 minimum; local Table R301.2(1); Local amendment to IRC Table R301.2(1). Your county or city publishes its own amendment to IRC Table R301.2(1) (or its own zone map), and that local document, not a state table, is what a permit reviewer checks. One call to the building department settles it before you rent an auger.
Plan a pour in Arizona
Other states
Last updated: 2026-11-02